pxt-tcs3200-color-sensor

for TCS3200 color sensor
S0, S1 used for output frequency scaling selection inputs. It is preset at 2%.
S2, S3 used in selection filter type.
OUT is frequency output pin.
VCC and GND for supply voltage and ground.
It takes some time to calibrate the sensor. When calibrating the sesnor, “C” is shown in the display or you can use the serial monitor for more details.
check Footnotes for more details.

Blocks

Calibration

To calibrate the color sensor. You can specify the calibration time for each color, the longer it takes to calibrate, the more accurate it will be (theoretically).

Connect the sensor to a micro:bit. Set up the pins and place the sensor in white paper then start running the block.

color

Return the RGB value (0 - 255) for selected color.

TODO (package)

Add a reference for your blocks here
Add “icon.png” image (300x200) in the root folder
Add “- beta” to the GitHub project description if you are still iterating it.
Turn on your automated build on https://travis-ci.org
Use “pxt bump” to create a tagged release on GitHub
Get your package reviewed and approved https://makecode.microbit.org/packages/approval

Read more at https://makecode.microbit.org/packages/build-your-own

License

MIT

Supported targets

for PXT/microbit
```
GitHub: BLstem/pxt-tcs3200-color-sensor
```
(The metadata above is needed for package search.)

Footnotes

datasheet: https://www.mouser.com/catalog/specsheets/TCS3200-E11.pdf

This site is open source. Improve this page.